DTC P0010 Camshaft Position "A" Actuator Circuit (Bank 1) |

| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0010 | Open or short in OCV circuit (1 trip detection logic) |
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (OPERATE OCV) |
Connect an intelligent tester to the DLC3.
Start the engine and turn the tester on.
Warm up the engine.
Select the following menu items: Powertrain / Engine and ECT / Active Test / Activate the VVT System (Bank 1).
Check the engine speed while operating the Oil Control Valve (OCV) using the tester.
| Tester Operations | Specified Conditions |
| OCV OFF | Normal engine speed |
| OCV ON | Engine idles roughly or stalls (soon after OCV switched from OFF to ON) |
|
| ||||
| NG | |
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
![]() |
Disconnect the C24 OCV connector.
Measure the resistance between the terminals of the OCV.
Reconnect the OCV connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (OCV - ECM) |
![]() |
Disconnect the C24 OCV connector.
Disconnect the C20 ECM connector.
Check the resistance.
| Tester Connections | Specified Conditions |
| OC1+ (C24-1) - OC1+ (C20-100) | Below 1 Ω |
| OC1- (C24-2) - OC1- (C20-123) |
| Tester Connections | Specified Conditions |
| OC1+ (C24-1) or OC1+ (C20-100) - Body ground | 10 kΩ or higher |
| OC1- (C24-2) or OC1- (C20-123) - Body ground |
Reconnect the OCV connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||