Home › ENGINE ยท 1NZ-FE › FUEL › FUEL TANK

FUEL TANK > REMOVAL

for Preparation Click here



1. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
  1. Remove the fuel suction with pump and gauge tube assembly (Click here).



2. DRAIN FUEL


3. REMOVE FRONT FLOOR HEAT INSULATOR NO. 4
  1. Remove the 2 nuts and remove the insulator.



4. REMOVE FUEL TANK COVER VENT CASE SUB-ASSEMBLY
  1. Remove the bolt and clip and remove the case.



5. DISCONNECT FUEL TANK BREATHER HOSE


A118741
  1. Loosen the clamp bolt and disconnect the fuel tank breather hose.



6. DISCONNECT FUEL TANK TO FILLER PIPE HOSE


A118742
  1. Loosen the clamp and disconnect the fuel tank to filler pipe hose.



7. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


A109384J01
  1. Release the lock as shown in the illustration, then pull and remove the fuel tank main tube.

    NOTICE:
    1. Remove any dirt and foreign matter from the clip before performing this work.
    2. Avoid any scratches or foreign matter on the parts when disconnecting, as the quick connector has the O-ring that seals the plug.
    3. Perform this work by hand. Do not use any tools.
    4. Do not forcibly bend, twist or turn the nylon tube.
    5. Protect the disconnected parts by covering them with a plastic bag.
    6. If the connector and pipe are stuck, disconnect the nylon tube by turning it by hand to release it.



8. DISCONNECT FUEL EMISSION TUBE NO. 2


A119220
  1. Loosen the clamp and disconnect fuel emission tube No. 2.



9. REMOVE FUEL TANK ASSEMBLY


A105615
  1. Set the mission jack under the fuel tank.

  1. Remove the 4 bolts and the fuel tank.



10. REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY


A125130
  1. Remove the fuel tank main tube from the fuel tank.



11. REMOVE FUEL EMISSION TUBE NO.2


A118747
  1. Remove fuel emission tube No. 2 from the fuel tank.



12. REMOVE FUEL TANK BREATHER TUBE


A118754
  1. Loosen the clamp bolt and remove the fuel tank breather hose.