Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND PULLEY (for 1NZ-FE, 2NZ-FE)

COMPRESSOR AND PULLEY (for 1NZ-FE, 2NZ-FE) > REMOVAL

for Preparation Click here



1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Switch A/C ON.

  1. Turn the blower switch to ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

  1. Stop the engine.



    I101550E01
  1. Remove the caps from the service valves on the refrigerant line.

  1. Connect the Freon collection/recycling device to discharge the refrigerant gas remaining in the refrigeration system.

    NOTICE:
    Use the Freon collection/recycling device in accordance with the manufacturer's instruction manual.



2. REMOVE ENGINE UNDER COVER RH


3. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY (for Rough Road Area Specification Vehicles)


4. REMOVE FAN & GENERATOR V BELT (for 1NZ-FE)


    A116197E01
  1. Loosen bolts A and B.

  1. Release the fan and generator V belt tension and remove the fan and generator V belt.



5. REMOVE FAN & GENERATOR V BELT (for 2NZ-FE)


    A116197E01
  1. Loosen bolts A and B.

  1. Release the fan and generator V belt tension and remove the fan and generator V belt.



6. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE


I101564
  1. Remove the bolt and disconnect the suction hose.

  1. Remove the O-ring from the suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



7. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


I101565
  1. Remove the bolt and disconnect the discharge hose.

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



8. REMOVE COMPRESSOR AND PULLEY


I101225
  1. Disconnect the connector and the clamp.

  1. Remove the 4 bolts and compressor.