Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY (for Hatchback)

HEADLIGHT ASSEMBLY (for Hatchback) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.
  3. Set the headlight leveling switch to 0 (zero) before conducting the procedure.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT BUMPER COVER


    B185052E01
  1. Apply protective tape as shown in the illustration.



    B185053
  1. Remove the 8 screws.

  1. Remove the 2 screw grommets.

  1. Remove the 7 clips.



    B185054E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.

  1. Disconnect the 2 connectors.

    HINT:
    If the vehicle is equipped with fog lights, disconnect the connectors.



    B114366
  1. Remove the 2 clips and the screw grommet.



3. REMOVE HEADLIGHT ASSEMBLY


E107913
  1. Remove the 3 screws.

  1. w/ Headlight leveling:
    Disconnect the 4 connectors, then remove the headlight.

  1. w/o Headlight leveling:
    Disconnect the 3 connectors, then remove the headlight.