FUEL PUMP > INSTALLATION |
| 1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
![]() |
Install a new fuel suction tube gasket onto the fuel tank.
![]() |
Align the protrusion of the fuel pump with the cutout of the fuel tank and install the fuel suction with pump and gauge tube assembly.
| 2. INSTALL FUEL PUMP GAUGE RETAINER |
![]() |
Using SST, turn the retainer 540° clockwise from the screw starting point and align the claw of the retainer with the matchmark on the fuel tank.
| 3. CONNECT CANISTER OUTLET HOSE SUB-ASSEMBLY NO. 1 |
![]() |
Connect the canister outlet hose.
| 4. CONNECT FUEL EMISSION TUBE NO. 2 |
![]() |
Connect fuel emission tube No. 2.
| 5. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Insert the fuel tank main tube.
Install the tube joint clip.
| 6. INSTALL REAR FLOOR SERVICE HOLE COVER |
![]() |
Connect the fuel pump connector.
![]() |
Install the rear floor service hole cover with new butyl tape.
| 7. INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Sedan) |
![]() |
Pass the rear seat inner belt through the rear seat cushion slit.
Engage the 3 hooks and install the rear seat cushion cover pad.
| 8. INSTALL REAR SEAT ASSEMBLY (for Hatchback) |
![]() |
Insert the 2 location pins through the 2 body holes and install the rear seat.
Using "TORX" socket wrench E10, install the 4 bolts in the sequence shown in the illustration.
![]() |
Install the rear seat cushion.
Using "TORX" socket wrench E10, install the 3 bolts in the sequence shown in the illustration.
| 9. INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hatchback Bench Seat Type) |
![]() |
Pass the rear seat inner belt through the slit in the rear seat cushion.
Engage the 3 hooks and install the rear seat cushion.
| 10. INSTALL REAR SEAT LEG COVER NO. 2 (for Hatchback) |
![]() |
Engage the 3 claws and install the No. 2 rear seat leg cover.
| 11. INSTALL REAR SEAT LEG COVER NO. 1 (for Hatchback) |
![]() |
Engage the 4 claws and install the No. 1 rear seat leg cover.
| 12. INSTALL DECK FLOOR BOX (w/ Deck Board) |
![]() |
Install the deck floor box and lock the 2 knobs.
| 13. INSTALL SPARE WHEEL COVER ASSEMBLY (w/ Deck Board) |
![]() |
Install the spare wheel cover.
| 14. INSTALL DECK BOARD SUB-ASSEMBLY (w/ Deck Board) |
![]() |
Set the deck board and lock the 2 knobs.
| 15. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim) |
![]() |
Engage the 2 claws and install the package tray trim panel.
Install the 5 pieces of hook tape.
Install the 2 package tray trim suspenders.
| 16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 17. INSPECT FOR FUEL LEAK |
When using the intelligent tester.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and the intelligent tester main switch on.
Select the Active Test mode on the intelligent tester.
Check that there is no fuel leakage anywhere in the fuel system after doing maintenance.