DTC P0327 Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor) |
DTC P0328 Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0327 | Output voltage of knock sensor is 0.5 V or less (1 trip detection logic) |
|
| P0328 | Output voltage of knock sensor is 4.5 V or more (1 trip detection logic) |
|

| Item | Content |
| Terminals | KNK1 - EKNK |
| Equipment Settings | 1 V/Division, 1 msec./Division |
| Conditions | Keep engine speed at 4,000 rpm with warm engine |

| 1.READ VALUE USING INTELLIGENT TESTER (KNOCK FEEDBACK VALUE) |
Connect an intelligent tester to the DLC3.
Start the engine and turn the tester on.
Warm up the engine.
Select the following menu items: Powertrain / Engine and ECT / Data List / Knock Feedback Value.
Read the values displayed on the tester while driving the vehicle.
| Malfunction does not occur | Knock Feedback Values change |
| Malfunctions occur | Knock Feedback Values do not change |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - KNOCK SENSOR) |
![]() |
Disconnect the C20 ECM connector.
Measure the resistance between the terminals.
| Tester Connections | Specified Conditions |
| KNK1 (C20-110) - EKNK (C20-111) | 120 to 280 kΩ at 20°C (68°F) |
Reconnect the ECM connector.
|
| ||||
| OK | |
| 3.INSPECT ECM (KNK1 VOLTAGE) |
![]() |
Disconnect the P1 knock sensor connector.
Turn the ignition switch to ON.
Measure the voltage between the knock sensor terminals.
| Tester Connections | Specified Conditions |
| KNK1 (P1-2) - EKNK (P1-1) | 4.5 to 5.5 V |
Reconnect the knock sensor connector.
|
| ||||
| OK | ||
| ||
| 4.INSPECT KNOCK SENSOR |
![]() |
Remove the knock sensor (Click here).
Measure the resistance between the terminals.
| Tester Connections | Specified Conditions |
| KNK1 (2) - EKNK (1) | 120 to 280 kΩ at 20°C (68°F) |
Reinstall the knock sensor (Click here).
|
| ||||
| OK | ||
| ||