DTC P0420 Catalyst System Efficiency Below Threshold (Bank 1) |


| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0420 | The ratio of the signal lengths (the signal length of oxygen sensor 2 / the signal length of oxygen sensor 1) smaller than standard value (2 trip detection logic) |
|



| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0420) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Display (DTC Output) | Proceed To |
| P0420 | A |
| P0420 and other DTCs | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (CONTROL THE INJECTION VOLUME) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON.
Warm up the engine by running the engine at 2,500 rpm for approximately 90 seconds.
Select the following menu items: Powertrain / Engine and ECT / Active Test / Control the Injection Volume for A/F Sensor.
Perform the Active Test while the engine is idling.
| Case | Heated Oxygen Sensor (Sensor 1) Output Voltage | Heated Oxygen Sensor (Sensor 2) Output Voltage | Main Suspected Trouble Area |
| 1 | ![]() ![]() | ![]() ![]() | - |
| 2 | ![]() ![]() | ![]() ![]() |
|
| 3 | ![]() ![]() | ![]() ![]() |
|
| 4 | ![]() ![]() | ![]() ![]() |
|
| Result | Proceed To |
| Case 1 | A |
| Case 2 | B |
| Case 3 | C |
| Case 4 | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 3.CHECK FOR EXHAUST GAS LEAK |
|
| ||||
| OK | ||
| ||
| 4.CHECK FOR EXHAUST GAS LEAK |
|
| ||||
| OK | ||
| ||