Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for Sedan)

FRONT DOOR SPEAKER (for Sedan) > INSTALLATION

for Preparation Click here


HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY


    B134970E01
  1. Using an air riveter or hand riveter, install the front No. 1 speaker with 3 new strike rivets.

    HINT:
    Install the new strike rivets in the order shown in the illustration.

    NOTICE:

    1. B130465
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. B130466
      Confirm that the rivets are seated properly against the speaker.
    3. Do not tilt the riveter when installing the rivet onto the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. B130467
      Do not leave any space between the speaker and door. Firmly hold the 2 items together while installing the rivet.



    B134972
  1. Connect the speaker connector.



2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the LH side .



3. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the LH side .



4. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

HINT:
Use the same procedure as for the LH side .



5. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

HINT:
Use the same procedure as for the LH side .



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }