Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for Hatchback)

FRONT DOOR SPEAKER (for Hatchback) > INSTALLATION

for Preparation Click here


HINT:
The procedure listed below is for the LH side. Use the same procedure for both the RH and LH side, unless otherwise specified.



1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY


    E107769E01
  1. Using an air riveter or hand riveter, install the front No. 1 speaker assembly onto the front door panel with 3 new strike rivets.

    HINT:
    Install the new strike rivets in the order shown in the illustration.

    NOTICE:

    1. H002440
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. H002441
      Confirm that the rivets are seated properly against the speaker.
    3. Do not tilt the riveter when installing the rivet onto the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. H002442
      Do not leave any space between the speaker and door. Firmly hold the 2 items together while installing the rivet.



    E107770
  1. Connect the connector.



2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


B127219
  1. Connect the front door lock remote control cable and front door inside locking cable.



    B116821
  1. 5 Door:
    Engage the 8 clips and install the front door trim board.



    B116822
  1. 3 Door:
    Engage the 9 clips and install the front door trim board.



    B107840
  1. Tighten the 4 screws.



3. INSTALL FRONT ARMREST BASE PANEL UPPER


B116819
  1. Connect the connector.

  1. Engage the 5 claws and clip and install the front armrest base panel upper.



4. INSTALL DOOR ARMREST COVER


B116818
  1. for 5 Door:
    Engage the 8 claws and 3 clips and install the door armrest cover.



    B116851
  1. for 3 Door:
    Engage the 12 claws and 4 clips and install the door armrest cover.



5. INSTALL DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B116863
  1. Install the window regulator handle plate.

  1. Open all the windows.



    B116947E01
  1. Install the front door window regulator handle with clip at the angle shown in the illustration.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }