Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR DOOR SPEAKER (for Hatchback 5 Door)

REAR DOOR SPEAKER (for Hatchback 5 Door) > INSTALLATION

for Preparation Click here


HINT:
The procedure listed below is for the LH side. Use the same procedure for both the RH and LH side, unless otherwise specified.



1. INSTALL REAR SPEAKER ASSEMBLY


    E107772E01
  1. Using an air riveter or hand riveter, install the front No. 1 speaker assembly onto the front door panel with 3 new strike rivets.

    HINT:
    Install the new strike rivets in the order shown in the illustration.

    NOTICE:

    1. H002440
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. H002441
      Confirm that the rivets are seated properly against the speaker.
    3. Do not tilt the riveter when installing the rivet onto the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. H002442
      Do not leave any space between the speaker and door. Firmly hold the 2 items together while installing the rivet.



    E107773
  1. Connect the connector.



2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY


B116868
  1. Connect the rear door lock remote control cable and rear door inside locking cable.

  1. Connect the connector.



    B116867
  1. Engage the 7 clips and install the rear door trim board.



    B116866
  1. Tighten the 2 screws.



    B116865
  1. Engage the 3 claws and install the rear door armrest plug.



3. INSTALL DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B116863
  1. Install the window regulator handle plate.

  1. Open all the windows.



    B121530E01
  1. Install the rear door window regulator handle with the clip at the angle shown in the illustration.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }