Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for Hatchback)

FRONT DOOR SPEAKER (for Hatchback) > REMOVAL

for Preparation Click here


HINT:
The procedure listed below is for the LH side. Use the same procedure for both the RH and LH side, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B116850
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the front door window regulator handle and clip.

  1. Remove the window regulator handle plate.



3. REMOVE DOOR ARMREST COVER


B116818
  1. for 5 Door:
    Using a screwdriver with its tip wrapped in protective tape, disengage the 8 claws and 3 clips and remove the door armrest cover.



    B116851
  1. for 3 Door:
    Disengage the 12 claws and 3 clips and remove the door armrest cover.



4. REMOVE FRONT ARMREST BASE PANEL UPPER


B116819
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws and clip and remove the front armrest base panel upper.

  1. Disconnect the connector.



5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


B107840
  1. Remove the 4 screws.



    B116821
  1. 5 Door:
    Disengage the 8 clips.



    B116822
  1. 3 Door:
    Disengage the 9 clips.



    B127219
  1. Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board.



6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    E107768
  1. Disconnect the connector.

  1. Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the front No.1 speaker assembly from the front door panel.

  1. Operate the drill around the rivet head circumference and cut out the flange.

    CAUTION:
    Be careful. The cut rivet is very hot.

    NOTICE:
    Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.

  1. After drilling out the flange, continue drilling to push out the shards on the drill.

  1. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.