Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR DOOR SPEAKER (for Hatchback 5 Door)

REAR DOOR SPEAKER (for Hatchback 5 Door) > REMOVAL

for Preparation Click here


HINT:
The procedure listed below is for the LH side. Use the same procedure for both the RH and LH side, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B116942
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door window regulator handle assembly and clip.

  1. Remove the window regulator handle plate.



3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


B116864E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the rear door armrest plug.



    B116866
  1. Remove the 2 screws.



    B116867
  1. Disengage the 7 clips.

  1. Disconnect the connector.



    B116868
  1. Disconnect the rear door lock remote control cable and rear door inside locking cable and remove the rear door trim board.



4. REMOVE REAR SPEAKER ASSEMBLY


    E107771
  1. Disconnect the connector.

  1. Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the rear speaker assembly from the rear door panel.

  1. Operate the drill around the rivet head circumference and cut out the flange.

    CAUTION:
    Be careful. The cut rivet is very hot.

    NOTICE:
    Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.

  1. After drilling out the flange, continue drilling to push out the shards on the drill.

  1. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.