Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SPIRAL CABLE (for Hatchback)

SPIRAL CABLE (for Hatchback) > INSPECTION

for Preparation Click here



1. INSPECT SPIRAL CABLE


C123150E01
  1. Check the spiral cable.

    1. Using an ohmmeter, measure the resistance between the terminals.

      1. Set the spiral cable in the center, and measure the resistance in each position where the spiral cable is turned 2.5 times clockwise and counterclockwise.
      2. Set the spiral cable in a position where it is turned 2.5 times clockwise from the original position, and measure the resistance while turning it 5 times counterclockwise.

      Standard resistance:
      Terminals
      Standard
      A2(D+) - D1(D+)
      Below 1Ω
      A1(D-) - D2(D-)
      Below 1Ω
      B5(HO) - C2(HO)
      Below 1Ω

      NOTICE:
      To avoid breakage of the spiral cable, do not turn the spiral cable more than necessary. If the result is not as specified, replace the spiral cable.