Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY (for Hatchback)

CENTER AIRBAG SENSOR ASSEMBLY (for Hatchback) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


B208627
  1. Remove the shift lever knob.



3. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)


B208631
  1. Disengage the 6 claws and remove the shifting hole cover.



4. REMOVE FRONT ASH RECEPTACLE ASSEMBLY


5. REMOVE CONSOLE BOX COVER REAR


C109006E01
  1. Disengage the 8 claws and remove the console box rear cover.



6. REMOVE CONSOLE BOX CARPET


C109008
  1. Remove the console box carpet.



7. REMOVE CONSOLE BOX ASSEMBLY REAR


C116873
  1. Remove the bolt and disengage the 2 clips to remove the console box.



8. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


B106565E01

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. Pull the lever down and detach the connector holder.



    B106566
  1. Remove the 3 bolts and remove the airbag sensor.