Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING UNIT (for Hatchback)

AIR CONDITIONING UNIT (for Hatchback) > INSPECTION

for Preparation Click here



1. INSPECT DAMPER SERVO MOTOR SUB-ASSEMBLY


    E055982E03
  1. Connect the positive (+) battery lead to terminal 5 of each servo motor and the negative (-) battery lead to terminal 4. Check that the damper operates smoothly.



    E055982E01
  1. Connect the positive (+) battery lead to terminal 4 of each servo motor and the negative (-) battery lead to terminal 5. Check that the damper operates smoothly.



2. INSPECT NO. 1 COOLER THERMISTOR


E113141E02
  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    -10°C (14°F)
    7.30 to 9.10 kΩ
    1 - 2
    -5°C (23°F)
    5.65 to 6.95 kΩ
    1 - 2
    0°C (32°F)
    4.40 to 5.35 kΩ
    1 - 2
    5°C (41°F)
    3.40 to 4.15 kΩ
    1 - 2
    10°C (50°F)
    2.70 to 3.25 kΩ
    1 - 2
    15°C (59°F)
    2.14 to 2.58 kΩ
    1 - 2
    20°C (68°F)
    1.71 to 2.05 kΩ
    1 - 2
    25°C (77°F)
    1.38 to 1.64 kΩ
    1 - 2
    30°C (86°F)
    1.11 to 1.32 kΩ

    NOTICE:
    1. Touching the sensor even slightly may change the resistance value. Hold the connector of the sensor.
    2. When measuring the resistance, the temperature of the sensor and the cooler thermistor must be the same.

    HINT:
    As the temperature increases, the resistance decreases (see the graph).

    If the operation is not as specified, replace the cooler thermistor.



3. INSPECT PTC HEATER ASSEMBLY


E115947
  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 - 2
    Below 1 Ω
    2 - 3
    Below 1 Ω
    1 - 3
    Below 1 Ω

    If the resistance value is not as specified, replace the PTC heater assembly.