Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR

AIR CONDITIONING PRESSURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT PRESSURE SENSOR


    E110988E04
  1. Check the wire harness.

    1. Disconnect the connector of the pressure sensor.

    2. Using an ohmmeter, measure the resistance of the wire harness side connector.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - Body ground
      Below 1 Ω

    3. Turn the ignition switch on (IG).

    4. Measure the voltage of the wire harness side connector.

      Standard voltage:
      Tester Connection
      Specified Condition
      1 - 3
      4.7 to 5.3 V



    I100855E02
  1. Check the pressure sensor.

    1. Set the manifold gauge.

    2. Connect the connector to the pressure sensor.

    3. Warm up the engine.

    4. Switch A/C ON.

    5. Using a voltmeter, measure the voltage between connector terminals (PRE) and (SG-2) of the air conditioner amplifier.

      HINT:
      Check from the rear of the connector while it is connected to the air conditioning amplifier.

      Standard voltage:
      Type
      Tester Connection
      Refrigerant Pressure
      Specified Condition
      Manual Air Conditioning
      6 (PRE) - 11 (SG-1)
      0.196 to 3.14 MPa (2.0 to 32 kgf/cm2)
      0.76 to 4.74 V
      Automatic Air Conditioning
      9 (PRE) - 13 (SG-1)
      0.196 to 3.14 MPa (2.0 to 32 kgf/cm2)
      0.76 to 4.74 V