Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Only Driver Door LOCK / UNLOCK Functions do not Operate

for Preparation Click here


DESCRIPTION

The main body ECU receives lock/unlock switch signals and activates the door lock motor accordingly.

WIRING DIAGRAM


B109873E15


INSPECTION PROCEDURE

1.INSPECT FRONT DOOR LOCK ASSEMBLY (DRIVER SIDE)


    B079551E05
  1. LHD:

    1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1
      Lock
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      Unlock



  1. RHD:



      B118058E07
    1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1
      Lock
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      Unlock



NG
REPLACE FRONT DOOR LOCK ASSEMBLY (DRIVER SIDE)
OK


2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - DRIVER SIDE FRONT DOOR LOCK ASSEMBLY)


    B146194E02
  1. LHD:

    1. Disconnect the 4H main body ECU connector.

    2. Disconnect the G5 door lock connector.

    3. Measure the resistance of the wire harness side connectors.

      Standard resistance:
      Tester Connection
      Specified Condition
      4H-17 (ACT+) - G5-4 (L)
      Below 1 Ω
      4H-9 (ACT-) - G5-1 (UL)
      Below 1 Ω
      4H-17 (ACT+) or G5-4 (L) - Body ground
      10 kΩ or higher
      4H-9 (ACT-) or G5-1 (UL) - Body ground
      10 kΩ or higher

    4. Reconnect the main body ECU connector.

    5. Reconnect the door lock connector.

  1. RHD:

    1. Disconnect the and 4H main body ECU connector.

    2. Disconnect the F5 door lock connector.

    3. Measure the resistance of the wire harness side connectors.

      Standard resistance:
      Tester Connection
      Specified Condition
      4H-8 (ACT+) - F5-4 (L)
      Below 1 Ω
      4H-18 (ACT-) - F5-1 (UL)
      Below 1 Ω
      4H-8 (ACT+) or F5-4 (L) - Body ground
      10 kΩ or higher
      4H-18 (ACT-) or F5-1 (UL) - Body ground
      10 kΩ or higher

    4. Reconnect the main body ECU connector.

    5. Reconnect the door lock connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU