Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Only Rear Door LH LOCK / UNLOCK Functions do not Operate

for Preparation Click here


DESCRIPTION

The main body ECU receives lock/unlock switch signals and activates the door lock motor accordingly.

WIRING DIAGRAM


B109873E06


INSPECTION PROCEDURE

1.INSPECT REAR DOOR LOCK ASSEMBLY LH


    B107859E01
  1. LHD:

    1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1
      Lock
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      Unlock



    B107859E03
  1. RHD:

    1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1
      Lock
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Unlock



NG
REPLACE REAR DOOR LOCK ASSEMBLY LH
OK


2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - REAR DOOR LOCK ASSEMBLY LH)
B123824E01
  1. LHD:

    1. Disconnect the 4A main body ECU connector.

    2. Disconnect the I3 door lock connector.

    3. Measure the resistance of the wire harness side connectors.

      Standard resistance:
      Tester Connection
      Specified Condition
      4A-3 (ACT+) - I3-4
      Below 1 Ω
      4A-4 (ACT-) - I3-1
      Below 1 Ω
      4A-3 (ACT+) or I3-4 - Body ground
      10 kΩ or higher
      4A-4 (ACT-) or I3-1 - Body ground
      10 kΩ or higher

    4. Reconnect the main body ECU connector.

    5. Reconnect the door lock connector.

  1. RHD:

    1. Disconnect the 4A main body ECU connector.

    2. Disconnect the I3 door lock connector.

    3. Measure the resistance of the wire harness side connectors.

      Standard resistance:
      Tester Connection
      Specified Condition
      4A-3 (ACT+) - I3-4
      Below 1 Ω
      4A-4 (ACT-) - I3-1
      Below 1 Ω
      4A-3 (ACT+) or I3-4 - Body ground
      10 kΩ or higher
      4A-4 (ACT-) or I3-1 - Body ground
      10 kΩ or higher

    4. Reconnect the main body ECU connector.

    5. Reconnect the door lock connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU