Home › TRANSMISSION ยท U340E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC


    A107926E06
  1. DTCs which are stored in the ECM can be displayed with the intelligent tester and generic OBD scan tool.
    These scan tools can display pending DTCs and current DTCs. Some DTC are not stored if the ECM does not detect a malfunction during consecutive driving cycles. However, the detected malfunction during one driving cycle is stored as a pending DTC.

    1. Connect the intelligent tester to the Data Link Connector 3 (DLC3).

    2. Turn the ignition switch to ON.

    3. Select the following items: Powertrain / Engine and ECT / DTC / Current (or Pending)

    4. Confirm the DTCs and freeze frame data and then write them down.

    5. Confirm the details of the DTCs (Click here).

      NOTICE:
      When simulating a symptom with the scan tool to check the DTCs, use normal mode. For DTCs in the DIAGNOSTIC TROUBLE CODE CHART, which are subject to 2-trip detection logic, perform the following actions.

      Turn the ignition switch off after the symptom is simulated once. Then repeat the simulation process again. When the problem has been simulated twice, the MIL illuminates and the DTCs are recorded in the ECM.


CLEAR DTC WITH INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Select the following items: Powertrain / Engine and ECT / DTC / Clear


CLEAR DTC WITHOUT INTELLIGENT TESTER
  1. Disconnect the battery cable or remove the EFI and ETCS fuses from the engine room J/B for 60 seconds or more.