Home › TRANSMISSION ยท U441E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > CHECK MODE PROCEDURE

for Preparation Click here



DESCRIPTION
  1. Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1-trip detection logic.


CHECK MODE PROCEDURE


    A107926E06
  1. Make sure that the following conditions are met:

    1. Battery positive voltage 11 V or more
    2. Throttle valve fully closed
    3. Transaxle in the P or N position
    4. A/C switched OFF

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch to ON.

  5. Select the following items: Utility / Check Mode



  6. A076900E17
  7. Change the ECM to check mode. Make sure the MIL flashes as shown in the illustration.

    NOTICE:
    All DTCs and freeze frame data recorded are erased if: 1) the intelligent tester is used to change the ECM from normal mode to check mode or vice versa; or 2) during check mode, the ignition switch is turned from ON to ACC or off.
    Before check mode, make notes of the DTCs and freeze frame data.

  8. Start the engine. (The MIL goes off after the engine starts.)

  9. Perform MONITOR DRIVE PATTERN for the ECT test (Click here) or simulate the conditions of the malfunction described by the customer.

  10. After simulating the malfunction conditions, use the intelligent tester diagnosis selector to check the DTC and freeze frame data.