Home › TRANSMISSION ยท U441E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > MECHANICAL SYSTEM TESTS

for Preparation Click here



STALL SPEED TEST

HINT:
This test is to check the overall performance of the engine and transaxle by measuring the stall speeds in the D position

NOTICE:
  1. Do not perform the stall speed test for longer than 5 seconds.
  2. To ensure safety, perform this test in a wide, clear level area which provides good traction.
  3. The stall speed test must always be carried out by pairs of technicians. One technician must watch the wheels and wheel stoppers from outside the vehicle to make sure they do not slip, while the other performs the test.

  1. Connect the intelligent tester to the DLC3.

  2. Run the vehicle until the ATF (Automatic Transmission Fluid) temperature reaches 50° to 80°C (122° to 176°F).

  3. Allow the engine to idle with the air conditioning OFF.

  4. Chock all 4 wheels.

  5. Set the parking brake and keep the brake pedal firmly depressed with your left foot.

  6. Shift the shift lever to the D position.

  7. Depress the accelerator pedal all the way down with your right foot.

  8. Read the engine rpm (stall speed) and release the accelerator pedal immediately.

    Standard value:
    2,050 to 2,450 rpm


    Evaluation: 
    Test Result
    Possible Cause
    Stall speed is lower than standard value
    1. Stator one-way clutch is not operating properly
    2. Torque converter is faulty (Stall speed is less than standard value by 600 rpm or more)
    3. Engine power is insufficient
    Stall speed is higher than standard value
    1. Line pressure is too low
    2. Forward clutch (C1) is slipping
    3. One-way clutch NO. 2 (F2) is not operating properly


SHIFT TIME LAG TEST

HINT:
This test is to check the conditions of the direct clutch, forward clutch, 1st brake and reverse brake.

  1. Connect the intelligent tester to the DLC3.

  2. Run the vehicle until the ATF (Automatic Transmission Fluid) temperature reaches 50° to 80°C (122° to 176°F).

  3. Allow the engine to idle with the air conditioning OFF.

  4. Set the parking brake and keep the brake pedal firmly depressed with your left foot.

  5. Check the D range time lag.

    1. Shift the shift lever into the N position and wait for 1 minute. (*1)

    2. Shift the shift lever into the D position and measure the time until the shock is felt. (*2)

    3. Repeat procedures (*1) and (*2) three times, and calculate the average time of the three tests.

  6. Check the R range time lag.

    1. Shift the shift lever into the N position and wait for 1 minute. (*3)

    2. Shift the shift lever into the R position and measure the time until the shock is felt. (*4)

    3. Repeat procedures (*3) and (*4) three times, and calculate the average time of the three tests.

      Standard value:
      D range time lag is less than 1.2 seconds
      R range time lag is less than 1.5 seconds


      Evaluation : 
      Test Result
      Possible Cause
      D range time lag exceeds standard value
      1. Line pressure is too low
      2. Forward clutch (C1) is worn
      3. One-way clutch No. 2 (F2) is not operating properly
      R range time lag exceeds standard value
      1. Line pressure is too low
      2. Reverse clutch (C3) is worn
      3. 1st and reverse brake (B3) is worn