Home › TRANSMISSION ยท U441E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > HYDRAULIC TEST

for Preparation Click here



PERFORM HYDRAULIC TEST


    C117642
  1. Measure the line pressure.

    NOTICE:
    1. Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature 50° to 80°C (122° to 176°F).
    2. The line pressure test must always be carried out by pairs of technicians. One technician must observe the condition of the wheels and wheel stoppers outside the vehicle, while the other is performing the test.
    3. Prevent the SST hose from interfering with the exhaust pipe.
    4. This test must be conducted after checking and adjusting the engine.
    5. Perform this test with the air conditioning OFF.
    6. Do not continue the stall test for more than 5 seconds.


    1. Warm up the ATF.

    2. Lift the vehicle up.

    3. Remove the engine under cover.

    4. Remove the test plug on the transmission case center right side and connect SST.

      SST
      09992-00095   (09992-00231, 09992-00271)

    5. Connect the intelligent tester to the DLC3.

    6. Fully apply the parking brake and chock all 4 wheels.

    7. Start the engine and check the idling speed.

    8. Keep your left foot pressing firmly on the brake pedal and shift into the D position.

    9. Measure the line pressure when the engine is idling.

    10. Depress the accelerator pedal all the way down. Quickly read the highest line pressure when engine speed reaches stall speed.

    11. Perform the test in the R position in the same manner.

      Standard line pressure:

      Condition
      D position kPa (kgf / cm2, psi)
      R position kPa (kgf / cm2, psi)
      Idling
      372 to 407 kPa
      (3.8 to 4.2 kgf/cm2, 54 to 60 psi)
      588 to 683 kPa
      (6.0 to 7.0 kgf/cm2, 85 to 100 psi)
      Stall
      1,067 to 1,187 kPa
      (10.9 to 12.1 kgf/cm2, 155 to 172 psi)
      1,420 to 1,675 kPa
      (14.5 to 17.1 kgf/cm2, 206 to 243 psi)


      Evaluation: 
      Problem
      Possible Cause
      Measured values are higher than specified values in all positions
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      Measured values are lower than specified values in all positions
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      3. Oil pump defective
      Pressure is low in D position only
      1. D position circuit fluid leak
      2. Forward clutch defective
      Pressure is low in R position only
      1. R position circuit fluid leak
      2. Reverse clutch defective
      3. 1st and reverse brake defective