AUTOMATIC TRANSAXLE SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
![]() |
Measure the line pressure.
Warm up the ATF.
Lift the vehicle up.
Remove the engine under cover.
Remove the test plug on the transmission case center right side and connect SST.
Connect the intelligent tester to the DLC3.
Fully apply the parking brake and chock all 4 wheels.
Start the engine and check the idling speed.
Keep your left foot pressing firmly on the brake pedal and shift into the D position.
Measure the line pressure when the engine is idling.
Depress the accelerator pedal all the way down. Quickly read the highest line pressure when engine speed reaches stall speed.
Perform the test in the R position in the same manner.
| Condition | D position kPa (kgf / cm2, psi) | R position kPa (kgf / cm2, psi) |
| Idling | 372 to 412 kPa (3.8 to 4.2 kgf/cm2, 54 to 60 psi) | 553 to 623 kPa (5.6 to 6.4 kgf/cm2, 80 to 90 psi) |
| Stall | 1,126 to 1,226 kPa (11.5 to 12.5 kgf/cm2, 163 to 178 psi) | 1,664 to 1,864 kPa (17.0 to 19.0 kgf/cm2, 241 to 270 psi) |
| Problem | Possible Cause |
| Measured values are higher than specified values in all positions |
|
| Measured values are lower than specified values in all positions |
|
| Pressure is low in D position only |
|
| Pressure is low in R position only |
|