Home › TRANSMISSION ยท U441E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > INITIALIZATION

for Preparation Click here



RESET MEMORY

NOTICE:
  1. Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.
  2. The RESET MEMORY can only be performed using an intelligent tester.

HINT:
The ECM stores the conditions that the ECT controls the automatic transaxle assembly and engine assembly in accordance with those characteristics. Therefore, when the automatic transaxle assembly, engine assembly, or ECM is replaced, it is necessary to reset the memory so that the ECM can store the new information.
The reset procedure is as follows.

  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch to ON and push the intelligent tester main switch on.

  4. Perform the reset memory procedure from the main menu.



  5. Select the following items: Powertrain / Engine and ECT / Utility.

    CAUTION:
    After performing the RESET MEMORY, be sure to perform the ROAD TEST (Click here) as described earlier.

    HINT:
    The ECM stores learned values by performing the ROAD TEST.




    1. Tester menu flow:


      C130117E01