DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0711 | Either of following Condition (A) or (B) is met: Condition (A): All of (a), (b) and (c) are detected. (2-trip detection logic) (a) Intake air and engine coolant temperatures are more than -10°C (14°F) at engine start. (b) After normal driving for over 9 minutes and 8 km (5.0 miles) or more, ATF temperature is less than 10°C (50°F). (c) 19 minutes or more have elapsed after engine start. Condition (B): Both (a) and (b) are detected. (2-trip detection logic) (a) Engine coolant temperature is less than 35°C (95°F) at engine start. (b) ATF temperature is 100°C (212°F) or more when engine coolant temperature reaches 60°C (140°F). |
|
| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn on the tester.
Select the following items: Powertrain / Engine and ECT / Data List.
In accordance with the display on the tester, read the Data List.
| Item | Measurement Item/ Range (display) | Normal Condition |
| A/T Oil Temperature 1 | ATF Temperature Sensor Value/ min.: -40°C (-40°F) max.: 215°C (419°F) |
|
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or more | Short circuit |
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn on the tester.
Select the following items: Powertrain / Engine and ECT / DTC / Current or Pending.
Read the DTCs using the tester.
| Display (DTC output) | Proceed to |
| P0711 | A |
| P0711 and other DTCs | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION FLUID LEVEL |
|
| ||||
| OK | ||
| ||