DTC P0751 Shift Solenoid "A" Performance (Shift Solenoid Valve S1) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0751 | S1 stuck OFF malfunction*1: ECM determines there is malfunction when both of following conditions are met: (2-trip detection logic) (a) When ECM directs gearshift to switch to 1st gear, actual gear is shifted to 4th. (b) When ECM directs gearshift to switch to 4th gear, actual gear is shifted to 4th. |
|
| P0751 | S1 stuck ON malfunction*2: ECM determines that there is malfunction when both of following conditions are met: (2-trip detection logic) (a) When ECM directs gearshift to switch from 3rd to 4th gear, actual gear is not shifted as above. (b) When ECM directs gearshift to switch to 4th gear, engine speed surges by over 1,100 rpm. |
|
| Gearshift controlled by ECM | 1st | 2nd | 3rd | 4th |
|
*1: Actual gear position under S1 stuck OFF malfunction | 4th | 3rd | 3rd | 4th |
|
*2: Actual gear position under S1 stuck ON malfunction | 1st | 2nd | 2nd | 1st |
| ACTIVE TEST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn on the tester.
Select the following items: Powertrain / Engine and ECT / Active Test / Control the Shift Position.
In accordance with the display on the tester, perform the Active Test.
| Item | Test Details | Diagnostic Note |
| Control the Shift Position | [Test Details] Operate shift solenoid valve and set each shift position. [Vehicle Condition]
| Possible to check operation of shift solenoid valves. |
| Gearshift controlled by ECM | 1st | 2nd | 3rd | 4th |
| Shift solenoid valve S1 | ON | ON | OFF | OFF |
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0751) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn on the tester.
Select the following items: Powertrain / Engine and ECT / DTC / Current or Pending.
Read the DTCs using the tester.
| Display (DTC output) | Proceed to |
| P0751 | A |
| P0751 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT SHIFT SOLENOID VALVE S1 |
![]() |
Remove shift solenoid valve S1.
Measure the resistance.
| Tester Connection | Specified Condition |
| Solenoid Connector (S1) - Solenoid Body (S1) | 11 to 15 Ω at 20°C (68°F) |
Connect the positive (+) lead to the terminal of the solenoid connector and the negative (-) lead to the solenoid body to check the solenoid valve operation.
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
|
| ||||
| OK | ||
| ||