Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > CHECK MODE PROCEDURE

for Preparation Click here



CHECK MODE (SIGNAL CHECK): DTC CHECK


    A107926E09
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Select the SIGNAL CHECK, and proceed checking with the intelligent tester.

    NOTICE:
    Select the SIGNAL CHECK from the DTC CHECK screen displayed on the intelligent tester to clear the output DTCs (both present and past).

    HINT:
    1. DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
    2. Perform the check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through the normal diagnosis mode inspection.