Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Hatchback)

ANTI-LOCK BRAKE SYSTEM (for Hatchback) > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using an intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch to ON.

  5. Turn the tester on.

  6. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

  7. According to the display on the tester, read the Data List.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ABS Warning Light
    ABS warning light / ON or OFF
    ON: Warning light ON
    OFF: Warning light OFF
    -
    Brake Warning Light
    Brake warning light / ON or OFF
    ON: Warning light ON
    OFF: Warning light OFF
    -
    Stop Light SW
    Stop light switch / ON or OFF
    ON: Brake pedal depressed
    OFF: Brake pedal released
    -
    Parking Brake SW
    Parking brake switch / ON or OFF
    ON: Parking brake applied
    OFF: Parking brake released
    -
    Deceleration Sensor
    Acceleration sensor 1 reading /
    min.: -18.52 G,
    max.: 18.39 G
    Approximately -0.13 to 0.13 G while stationary
    Reading changes when vehicle is bounced
    Forward and Rearward G
    Forward and rearward G /
    min.: -25.11 m/sec.2,
    max.: 24.91 m/sec.2
    Min.: -25.11 m/sec.2
    Max.: 24.91 m/sec.2
    -
    FR Wheel Speed
    FR wheel speed sensor reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Actual wheel speed
    Similar speed as indicated on speedometer
    FL Wheel Speed
    FL wheel speed sensor reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Actual wheel speed
    Similar speed as indicated on speedometer
    RR Wheel Speed
    RR wheel speed sensor reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Actual wheel speed
    Similar speed as indicated on speedometer
    RL Wheel Speed
    RL wheel speed sensor reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Actual wheel speed
    Similar speed as indicated on speedometer
    Vehicle Speed
    Maximum wheel speed sensor reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Actual vehicle speed
    Speed indicated on speedometer
    FR Wheel Acceleration
    FR wheel acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
    0 m/s2
    -
    FL Wheel Acceleration
    FL wheel acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
    0 m/s2
    -
    RR Wheel Acceleration
    RR wheel acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
    0 m/s2
    -
    RL Wheel Acceleration
    RL wheel acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
    0 m/s2
    -
    FR Wheel ABS Ctrl Status
    FR wheel ABS control status / ON or OFF
    ON: During the control
    -
    FL Wheel ABS Ctrl Status
    FL wheel ABS control status / ON or OFF
    ON: During the control
    -
    RR Wheel ABS Ctrl Status
    RR wheel ABS control status / ON or OFF
    ON: During the control
    -
    RL Wheel ABS Ctrl Status
    RL wheel ABS control status / ON or OFF
    ON: During the control
    -
    RR Wheel EBD Ctrl Status
    RR wheel EBD control status / ON or OFF
    ON: During the control
    -
    RL Wheel EBD Ctrl Status
    RL wheel EBD control status / ON or OFF
    ON: During the control
    -
    Solenoid Relay
    ABS solenoid relay / ON or OFF
    ON: Solenoid relay ON
    OFF: Solenoid relay OFF
    -
    ECB (Electronically Controlled Brake system) Motor Relay
    ABS motor relay / ON or OFF
    ON: Motor relay ON
    OFF: Motor relay OFF
    -
    ABS Solenoid (SFRH)
    ABS solenoid (SFRH) / ON or OFF
    ON: Operates
    -
    ABS Solenoid (SFRR)
    ABS solenoid (SFRR) / ON or OFF
    ON: Operates
    -
    ABS Solenoid (SFLH)
    ABS solenoid (SFLH) / ON or OFF
    ON: Operates
    -
    ABS Solenoid (SFLR)
    ABS solenoid (SFLR) / ON or OFF
    ON: Operates
    -
    ABS Solenoid (SRRH)
    ABS solenoid (SRRH) / ON or OFF
    ON: Operates
    -
    ABS Solenoid (SRRR)
    ABS solenoid (SRRR) / ON or OFF
    ON: Operates
    -
    ABS Solenoid (SRLH)
    ABS solenoid (SRLH) / ON or OFF
    ON: Operates
    -
    ABS Solenoid (SRLR)
    ABS solenoid (SRLR) / ON or OFF
    ON: Operates
    -
    FR Speed Open
    FR speed sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    FL Speed Open
    FL speed sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    RR Speed Open
    RR speed sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    RL Speed Open
    RL speed sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    Number of DTC
    Number of DTC recorded / Min.: 0, Max.: 255
    Min.: 0
    Max.: 255
    -


ACTIVE TEST

HINT:
Using an intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch to ON.

  5. Turn the tester on.

  6. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

  7. According to the display on the tester, perform the Active Test.

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    ABS Warning Light
    ABS warning light
    Warning light ON/OFF
    Observe combination meter
    Brake Warning Light
    Brake warning light
    Warning light ON/OFF
    Observe combination meter
    Solenoid Relay
    ABS solenoid relay
    Relay ON/OFF
    -
    Motor Relay
    ABS motor relay
    Relay ON/OFF
    Operating sound of motor can be heard
    ABS Solenoid (SRLR)
    ABS solenoid (SRLR)
    Solenoid ON/OFF
    Operating sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SRLH)
    ABS solenoid (SRLH)
    Solenoid ON/OFF
    Operating sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SRRR)
    ABS solenoid (SRRR)
    Solenoid ON/OFF
    Operating sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SRRH)
    ABS solenoid (SRRH)
    Solenoid ON/OFF
    Operating sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SFLR)
    ABS solenoid (SFLR)
    Solenoid ON/OFF
    Operating sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SFLH)
    ABS solenoid (SFLH)
    Solenoid ON/OFF
    Operating sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SFRR)
    ABS solenoid (SFRR)
    Solenoid ON/OFF
    Operating sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SFRH)
    ABS solenoid (SFRH)
    Solenoid ON/OFF
    Operating sound of solenoid (clicking sound) can be heard