AIR CONDITIONING PANEL (for Sedan) > INSTALLATION |
| 1. CONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY |
Engage the 2 claws and connect the air inlet damper control cable.
| 2. CONNECT DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY |
Engage the 2 claws and connect the defroster damper control cable.
| 3. CONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY |
Engage the 2 claws and connect the air mix damper control cable.
Connect the air mix damper control cable to the clamp.
| 4. INSTALL AIR CONDITIONING PANEL ASSEMBLY |
Connect the 3 connectors and the 4 clamps.
Engage the 4 clips and 2 claws and install the air conditioning panel.
| 5. INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY (except Integrated with Panel) |
Engage the 4 clips and 2 claws and install the instrument cluster finish panel.
| 6. INSTALL RADIO RECEIVER ASSEMBLY (for Integrated with Panel) |
Connect the plug.
Connect the 3 radio connectors.
![]() |
Align the 2 bosses of the instrument panel with the hole in the radio bracket.
Engage the 4 clips and 4 claws and install the radio receiver.
Tighten the 4 bolts.
Connect the hazard warning signal switch connector.
| 7. INSTALL INSTRUMENT CLUSTER FINISH PANEL NO.1 |
![]() |
Fit the 2 claws of the instrument cluster finish panel into the upper instrument cluster finish panel center.
![]() |
Engage the 5 claws and 5 clips and install the instrument cluster finish panel.
| 8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH |
![]() |
Engage the 6 claws and 3 clips and install the instrument panel finish panel end RH.
| 9. INSTALL INSTRUMENT PANEL FINISH PANEL END LH |
![]() |
Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.
| 10. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() |
Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.