Home › ENGINE ยท 2NZ-FE › FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY


E107724E01
  1. Check the fuel sender gauge resistance.

    1. Check that the float moves smoothly between the F level (upper end) and E level (lower end).

    2. Using an ohmmeter, measure the resistance.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      F (Upper End)
      12.0 to 18.0
      1 - 2
      E (Lower End)
      405.0 to 415.0

      If the result is not as specified, replace the fuel sender gauge assembly.