Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Sedan)

DTC    U0073    Control Module Communication Bus OFF

for Preparation Click here


DESCRIPTION

The skid control ECU receives the signal sent from the ECM via the CAN communication system. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.

DTC NO.
DTC Detection Condition
Trouble Area
U0073
When either of the following is detected:
  1. With terminal IG1 10 V or more, data output from skid control ECU is completed, and output continues for 5 seconds or more.
  2. With terminal IG1 10 V or more, bus off condition occurs once or more within 0.1 seconds, and this state continues 10 times or more.
CAN communication system

INSPECTION PROCEDURE

1.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Start the engine.

  1. Drive the vehicle and turn the steering wheel to the right and left at a speed of 15 km/h (9 mph) or more.

  1. Check for DTCs (Click here).

    HINT:
    If the CAN communication system DTC and the relevant sensor DTCs are output simultaneously, troubleshoot the relevant sensor DTCs (for ABS) after the CAN communication system returns to normal.

    Result 
    Result
    Proceed to
    DTC (relating to CAN communication system) is output
    A
    DTC (relating to ABS system) is output
    B
    DTC is not output
    C



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC (Click here)

C
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A

CHECK CAN COMMUNICATION SYSTEM (Click here)