Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM


E118194E03


INSPECTION PROCEDURE

1.INSPECT FUSE (ACC, AM1, DOME)
  1. Remove the ACC fuse and AM1 fuse from the main body ECU.

  1. Remove the DOME fuse from the engine room R/B.

  1. Measure the resistance of the fuses.

    Standard Resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - BATTERY AND BODY GROUND)
E106746E05
  1. Disconnect the D10 radio receiver connector.

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D10-4 (B) - Body ground
    Always
    11 to 14 V
    D10-3 (ACC) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D10-7 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)