AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit |

| 1.INSPECT FUSE (ACC, AM1, DOME) |
Remove the ACC fuse and AM1 fuse from the main body ECU.
Remove the DOME fuse from the engine room R/B.
Measure the resistance of the fuses.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the D10 radio receiver connector.
Measure the voltage.
| Tester Connection | Switch Condition | Specified Condition |
| D10-4 (B) - Body ground | Always | 11 to 14 V |
| D10-3 (ACC) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| D10-7 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||