Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Illumination Circuit

for Preparation Click here


DESCRIPTION

Power is supplied to the radio receiver and steering pad switch illumination when the light control switch is in the TAIL or HEAD position.

WIRING DIAGRAM


E170664E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuit related to this system before performing the following inspection procedure.

1.CHECK ILLUMINATION
  1. Check if the illumination for the radio receiver, steering pad switch, heater control switch or other components (hazard switch, door lock control switch, etc.) comes on when the light control switch is turned to the HEAD or TAIL position.
    Result 
    Result
    Proceed to
    Illumination comes on for all components except radio receiver.
    A
    No illumination comes on (radio receiver, hazard switch, heater control switch, etc.).
    B



B
GO TO LIGHTING SYSTEM (Click here)
A


2.CHECK HARNESS AND CONNECTOR (BATTERY - RADIO RECEIVER)


    E170663E01
  1. Disconnect the D10 radio receiver connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    D10-10 (ILL+) - Body ground
    Light control switch TAIL or HEAD
    11 to 14 V

  1. Reconnect the radio receiver connector.



NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH - RADIO RECEIVER)


    E170661E01
  1. Disconnect the D10 radio receiver connector.

  1. Disconnect the D4 headlight dimmer switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    D10-10 (ILL+) - D4-10 (TI)
    Always
    Below 1 Ω
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    D10-10 (ILL+) - D4-8 (TI)
    Always
    Below 1 Ω

  1. Reconnect the radio receiver connector.

  1. Reconnect the headlight dimmer switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO LIGHTING SYSTEM (Click here)