ENGINE IMMOBILISER SYSTEM > ECU Power Source Circuit |

| 1.INSPECT FUSE (ECU-B) |
![]() |
Remove the ECU-B fuse from the engine room R/B and J/B.
Measure the ECU-B fuse resistance.
Reinstall the ECU-B fuse.
|
| ||||
| OK | |
| 2.INSPECT FUSE (IGN) |
![]() |
Remove the IGN fuse from the main body ECU.
Measure the IGN fuse resistance.
Reinstall the IGN fuse.
|
| ||||
| OK | |
| 3.INSPECT INTEGRATION RELAY (IG2 RELAY AND AM2 FUSE) |
![]() |
Remove the integration relay from the engine room relay block.
Inspect the AM2 fuse.
Remove the AM2 fuse from the integration relay.
Measure the resistance.
Reinstall the AM2 fuse.
Inspect the IG2 relay.
Measure the resistance.
| Tester Connections | Specified Conditions |
| 1C-1 - 1B-4 | 10 kΩ or higher |
| Below 1 Ω (when battery voltage is applied to terminals 1B-2 and 1B-3) | |
| 1C-1 - 1B-1 | Below 1 Ω |
Reinstall the integration relay.
|
| ||||
| OK | |
| 4.INSPECT IGNITION SWITCH ASSEMBLY |
![]() |
Disconnect the D8 ignition switch connector.
Measure the resistance between the terminals shown below.
| Key Position | Tester Connection | Specified Condition |
| LOCK | - | 10 kΩor higher |
| ACC | 2 - 4 | Below 1 Ω |
| ON | 1 - 2 - 4 | Below 1 Ω |
| 5 - 6 | Below 1 Ω | |
| START | 1 - 3 - 4 | Below 1 Ω |
| 5 - 6 - 7 | Below 1 Ω |
Reconnect the ignition switch connector.
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the D23 transponder key ECU connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| D23-1 (+B) - Body ground | Always | 11 to 14 V |
| D23-2 (IG) - Body ground | Ignition switch OFF | Below 1 V |
| Ignition switch ON | 11 to 14 V |
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| D23-16 (GND) - Body ground | Below 1 Ω |
Reconnect the transponder key ECU connector.
|
| ||||
| OK | ||
| ||