Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2780    Push Switch / Key Unlock Warning Switch Malfunction

for Preparation Click here


DESCRIPTION

This DTC output if the transponder key ECU does not detect that the unlock warning switch is ON even when the ignition switch is ON. Under normal conditions, the unlock warning switch is ON when the ignition switch is ON.

DTC No.
DTC Detection Condition
Trouble Area
B2780
Unlock warning switch ON is not detected when ignition switch is ON
  1. Unlock warning switch assembly
  2. Wire harness
  3. Transponder key ECU assembly

WIRING DIAGRAM


B110397E04


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON with a key that cannot start the engine.

  1. On the intelligent tester, enter the following menus: Body/Immobiliser/Data List/Key SW. Read the result.

    Transponder key ECU assembly 
    Item
    Measurement Item/
    Display (Range)
    Normal Condition
    Diagnostic Note
    Key SW
    Unlock warning switch signal/
    ON or OFF
    OFF: No key is in ignition key cylinder
    ON: Key is in ignition key cylinder
    -

    OK:
    "ON" (key is in ignition key cylinder) appears on the screen.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY 

2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    B115726E01
  1. Remove the unlock warning switch.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    Below 1 Ω
    1 - 2
    Not pushed
    10 kΩ or higher

  1. Reinstall the unlock warning switch.



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH ASSEMBLY - BODY GROUND)


    B115727E01
  1. Disconnect the D19 unlock warning switch connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    D19-2 - Body ground
    Below 1 Ω

  1. Reconnect the unlock warning switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - UNLOCK WARNING SWITCH ASSEMBLY)
B115728E01
  1. Disconnect the D23 transponder key ECU connector.

  1. Disconnect the D19 unlock warning switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D23-3 (KSW) - D19-1
    Below 1 Ω

  1. Reconnect the unlock warning switch and transponder key ECU connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY