Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2799    Engine Immobiliser System Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when: 1) the ECM detects errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; and 3) the ECU communication ID between the transponder key ECU and the ECM are different and an engine start is attempted.
Before troubleshooting for this DTC, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs first.

DTC No.
DTC Detection Condition
Trouble Area
B2799
  1. Error in communication between ECM and transponder key ECU, and in communication line
  2. Communication IDs are different during communication with transponder key ECU
  1. Wire harness
  2. ECM

WIRING DIAGRAM


B115877E12


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - ECM)


    B116298E08
  1. Disconnect the D23 transponder key ECU connector.

  1. Disconnect the A21 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D23-13 (EFIO) - A21-11 (IMI)
    Below 1 Ω
    D23-12 (EFII) - A21-10 (IMO)
    Below 1 Ω
    D23-13 (EFIO) or A21-11(IMI) -
    Body ground
    10 kΩ or higher
    D23-12 (EFII) or A21-10(IMO) -
    Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM