Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC


    B145842E02
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the tester ON.

  4. Select the following menu items: Diagnosis / Body / Immobiliser / DTC.

  5. Check the DTC(s) and freeze frame data, and then write them down.

  6. Click here to check the details of the DTC(s).


CLEAR DTC (Using an intelligent tester)
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the tester ON.

  4. Select the following menu items: Diagnosis / Body / Immobiliser / DTC / Clear Codes.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

  5. Erase DTCs by pressing the YES button on the tester.

    HINT:
    Refer to the intelligent tester operator's manual for further details.


CLEAR DTC (Without using an intelligent tester)
  1. Remove the ECU-B fuse from the engine room R/B for more than 60 seconds, or disconnect the negative battery cable for more than 60 seconds. When disconnecting the negative battery cable, perform the "INITIALIZE" procedure.