Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC
B145842E01
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the intelligent tester ON.

  3. Select the following menu items: Body / Body ECU / DTC.

  4. Check DTCs and then write them down.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

  5. Confirm the details of the DTCs.


CLEAR DTC (using the intelligent tester)
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) (do not start the engine) and turn the intelligent tester ON.

  3. Select the following menu items: Body / Body ECU / DTC / Clear.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

  4. Erase DTCs by pressing the YES button on the tester.

    HINT:
    Refer to the intelligent tester operator's manual for further details.


CLEAR DTC (not using the intelligent tester)
  1. Remove the ECU-B fuse from the engine room R/B for more than 60 seconds, or disconnect the negative battery cable for more than 60 seconds. When disconnecting the negative battery cable, perform the "INITIALIZE" procedure.


SELF-DIAGNOSTIC MODE (OPERATING IGNITION KEY CYLINDER:)
  1. Switch to self-diagnostic mode.

    1. Establish the vehicle's initial conditions.

    2. Insert the key into the ignition key cylinder and remove it.

    3. Within 5 seconds of removing the key, insert it into the ignition key cylinder again.

    4. Turn the ignition switch on (IG) and then off.

    5. Within 30 seconds of turning the ignition switch off, perform the following operation 9 more times: Turn the ignition switch on (IG) and then off.

      HINT:
      1. Turning the ignition switch on (IG) after the procedure above has been completed ends the self-diagnostic mode.
      2. Do not lock or unlock doors during self-diagnostic mode.

      NOTICE:
      If the system cannot enter self-diagnostic mode, the system returns to normal mode.



  2. B110075E07
  3. Check that the system has switched to self-diagnostic mode by checking the flash pattern of the interior light.



  4. Check the diagnostic outputs when the door control transmitter switch is held down. The diagnostic outputs can be checked by the flash patterns of the interior light.


    B123864E01


SELF-DIAGNOSTIC MODE (USING INTELLIGENT TESTER)
  1. Switch to self-diagnostic mode.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG) and turn the intelligent tester main switch on.

      HINT:
      Refer to the intelligent tester operator's manual for further details.