Home › TRANSMISSION · U441E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

DTC    P0717    Turbine Speed Sensor Circuit No Signal

for Preparation Click here


DESCRIPTION

This sensor detects the rotation speed of the input turbine. By comparing the input turbine speed signal (NT) with the speed sensor signal (SPD), the ECM detects the shift timing of the gears and appropriately controls the engine torque and hydraulic pressure in response to various conditions, thus performing smooth gear shifting.

DTC No.
DTC Detection Condition
Trouble Area
P0717
ECM detects conditions (a), (b) and (c) continuously for 5 seconds or more.
(Except leaded gasoline sedan model: 1-trip detection logic)
(Leaded gasoline sedan model: 2-trip detection logic)
(a) Vehicle speed: 50 km/h (31 mph) or more
(b) Park/neutral position switch (NSW, R and L) is OFF.
(c) Transmission revolution sensor (speed sensor (NT)): Less than 300 rpm
  1. Open or short transmission revolution sensor (speed sensor (NT)) circuit
  2. Transmission revolution sensor (speed sensor (NT))
  3. Automatic transaxle (clutch, brake or gear etc.)
  4. ECM

MONITOR DESCRIPTION

The ECM detects the revolving signal from the transmission revolution sensor (input RPM). The ECM outputs a gearshift signal by comparing the transmission revolution sensor signal with the speed sensor signal (SPD). While the vehicle is operating in the 3rd or 4th gear position in the shift position of D, if the input shaft revolution is less than 300 rpm*1 although the output shaft revolution is more than 1,000 rpm*2, the ECM detects the malfunction, illuminates the MIL and stores the DTC.
*1: Pulse is not output or is irregularly output.
*2: The vehicle speed is 50 km/h (31 mph) or more.

WIRING DIAGRAM


C117932E01


INSPECTION PROCEDURE

1.INSPECT TRANSMISSION REVOLUTION SENSOR (NT) INSTALLATION


    BR03795E36
  1. Check the transmission revolution sensor installation.

    OK:
    The installation bolt is tightened properly and there is no clearance between the sensor and transmission case.



NG
SECURELY INSTALL OR REPLACE TRANSMISSION REVOLUTION SENSOR
OK


2.INSPECT TRANSMISSION REVOLUTION SENSOR
C110343E08
  1. Disconnect the transmission revolution sensor connector from the transaxle.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 - 2
    560 to 680 Ω at 20°C (68°F)



NG
SECURELY INSTALL OR REPLACE TRANSMISSION REVOLUTION SENSOR
OK


3.CHECK HARNESS AND CONNECTOR (TRANSMISSION REVOLUTION SENSOR - ECM)
A107892E04
  1. Connect the transmission revolution sensor connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    125 (NT+) - 124 (NT-)
    560 to 680 Ω at 20°C (68°F)
    125 (NT+) - Body ground
    10 kΩ or higher
    124 (NT-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM