Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › REAR AIRBAG SENSOR (for Sedan)

REAR AIRBAG SENSOR (for Sedan) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY
  1. for 60/40 Split Seat Type:

    1. Remove the rear seat cushion cover pad sub-assembly .

  1. for Fixed Seat Type:

    1. Remove the rear seat cushion cover pad sub-assembly .



3. REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type)


    B138450E02
  1. Remove the rear seat outer belt from the rear seat shoulder belt guide.

    HINT:
    Use the same procedure for both sides.

  1. for 3 Point Type Rear Center Seat belt:

    1. Remove the rear center seat outer belt from the rear center seat shoulder belt guide.



    B134981
  1. Remove the 3 bolts.

  1. Disengage the 3 hooks and remove the rear seatback.



4. REMOVE REAR SEATBACK ASSEMBLY LH (for 60/40 Split Seat Type)


    B134924
  1. Remove the rear seat outer belt from the rear seat shoulder belt guide.

  1. Pull the rear seatback lock release button and tilt the rear seatback forward.



    B134925
  1. Using a clip remover, remove the 2 clips and the rear seatback cover.



    B134926
  1. Remove the 2 bolts, the 2 hooks and the rear seatback.



5. REMOVE REAR SEATBACK ASSEMBLY RH (for 60/40 Split Seat Type)


    B134943
  1. Remove the rear seat outer belt from the rear seat shoulder belt guide.

  1. for 3 Point Type Rear Center Seat Belt:

    1. Remove the rear center seat outer belt from the rear center seat shoulder belt guide.

  1. Pull the rear seatback lock release button and tilt the rear seatback forward.



    B134944
  1. Using a clip remover, remove the 2 clips and the rear seatback cover.



    B134945
  1. Remove the 2 bolts, the 2 hooks and the rear seatback.



6. REMOVE LUGGAGE COMPARTMENT FLOOR MAT (for 60/40 Split Seat Type)


B136269
  1. Remove the luggage compartment floor mat.



7. REMOVE SPARE WHEEL COVER ASSEMBLY (for 60/40 Split Seat Type)


B136270
  1. Remove the spare wheel cover.



8. REMOVE LUGGAGE COMPARTMENT TRIM INNER PAD (for 60/40 Split Seat Type)


B136275
  1. Remove the luggage compartment trim inner pad.



9. REMOVE REAR DOOR SCUFF PLATE RH


    B134771
  1. Disengage the 7 claws and remove the rear door scuff plate.



10. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH


    B134772
  1. Remove the rear door opening trim weatherstrip.



11. REMOVE REAR SEAT SIDE COVER RH


    B134776
  1. Disengage the 2 clips and the 4 claws and remove the rear seat side cover.



12. REMOVE REAR AIRBAG SENSOR

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.



    B106579E01
  1. Slide the outer housing and detach the airbag connector.



    B106578E01
  1. Disengage the bolt and hook and remove the airbag sensor.