PARK / NEUTRAL POSITION SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE UNDER COVER LH |
| 3. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Remove the nut and disconnect the control cable from the control shaft lever.
Remove the clip and disconnect the control cable from the control cable bracket.
| 4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Disconnect the connector from the park/neutral position switch assembly.
![]() |
Remove the nut, washer and control shaft lever.
![]() |
Pry out the lock plate and remove the manual valve shaft nut.
![]() |
Remove the 2 bolts and pull out the park/neutral position switch assembly.