Home › TRANSMISSION ยท U441E AUTOMATIC TRANSAXLE › TRANSMISSION CONTROL CABLE ASSEMBLY (for Hatchback)

TRANSMISSION CONTROL CABLE ASSEMBLY (for Hatchback) > REMOVAL

for Preparation Click here



1. REMOVE BATTERY
  1. Disconnect the cable from the battery terminal.

  1. Loosen the nut and remove the battery clamp.

  1. Remove the battery.



2. REMOVE BATTERY TRAY


3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
  1. Remove the shift lever knob sub-assembly from the shift lever.



4. REMOVE CONSOLE BOX COVER REAR


C109006E01
  1. Disengage the 8 claws and remove the console box rear cover.



5. REMOVE CONSOLE BOX CARPET


C109008
  1. Remove the console box carpet.



6. REMOVE CONSOLE BOX ASSEMBLY REAR


C116873
  1. Remove the bolt and disengage the 2 clips to remove the console box.



7. SEPARATE OXYGEN SENSOR CONNECTOR


C117113
  1. Pull back the floor carpet and disconnect the oxygen sensor connector.

  1. Remove the grommet and put the oxygen sensor connector outside of the vehicle.



8. REMOVE AIR CLEANER ASSEMBLY


A117355
  1. Separate the intake air flow meter connector and wire harness clamp.

  1. Separate the fuel vapor feed hose and fuel vapor feed hose No. 1 from the vacuum switching valve assembly.

  1. Separate the vacuum switching valve connector and wire harness clamp.

  1. Separate the ventilation hose from the air cleaner hose.

  1. Release the air cleaner cap sub-assembly with air cleaner hose No. 1.

  1. Loosen the air cleaner hose clamp on the throttle body side and remove the air cleaner cap and air cleaner hose.

  1. Remove the air cleaner element.



    A104895
  1. Separate the wire harness clamp from the air cleaner case.

  1. Remove the 2 bolts and remove the air cleaner case with air cleaner inlet No. 1.



9. REMOVE AIR CLEANER BRACKET


A117308
  1. Separate the wire harness clamp from the air cleaner bracket.

  1. Remove the 2 bolts and remove the air cleaner bracket.



10. REMOVE EXHAUST PIPE ASSEMBLY FRONT
  1. Remove the 2 bolts and 2 springs and separate the exhaust tail pipe assembly.

  1. Remove the 2 bolts and 2 springs and separate the exhaust manifold.

  1. Remove the 3 exhaust pipe supports and remove the exhaust pipe assembly front.



11. REMOVE FRONT FLOOR HEAT INSULATOR NO.1


C117116E01
  1. Remove the 2 bolts and the nut and remove floor heat insulator No. 1.



12. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


C117115
  1. Disconnect the control cable from the shift lever.



    C117114E01
  1. Turn the nut and separate the control cable from the shift lever retainer.

  1. Disconnect the control cable from the control cable support.



    C107765
  1. Remove the nut and disconnect the control cable from the control shaft lever.

  1. Remove the clip and separate the control cable from the control cable bracket.



    C117117
  1. Remove the 3 nuts and remove the control cable.