TORQUE CONVERTER AND DRIVE PLATE > INSPECTION |
| 1. INSPECT TORQUE CONVERTER ASSEMBLY |
![]() |
Inspect the one-way clutch.
Install SST so that it fits into the notch on the converter hub and the notch on the outer race of the one-way clutch.
Press on the serrations of the stator with a finger and rotate it.
Check that it rotates smoothly when turned clockwise and locks up when turned counterclockwise.
![]() |
Check the condition of the torque converter.
If the inspection result of the torque converter meets any of the cases mentioned below, replace the torque converter.
Replace the ATF in the torque converter.
If the ATF is discolored and/or has a foul odor, completely stir the ATF in the torque converter and drain it with the installation surface facing up.
Clean and check the oil cooler and oil pipe line.
![]() |
If the torque converter is inspected or the ATF is changed, clean the oil cooler and oil pipe line.
If the ATF is cloudy, inspect the oil cooler (radiator).
![]() |
Prevent deformation of the torque converter and damage to the oil pump gear.
When any marks due to interference are found on the end of the bolt for the torque converter and on the bottom of the bolt hole, replace the bolt and torque converter.
All of the bolts should be the same length.
Make sure no spring washers are missing.
| 2. INSPECT DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
![]() |
Set up a dial indicator with a roller instrument and measure the drive plate runout.
Check the ring gear for damage.
If the runout is not within the specification or the ring gear is damaged, replace the drive plate and ring gear.