Home › TRANSMISSION ยท U340E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE UNIT

AUTOMATIC TRANSAXLE UNIT > INSPECTION

for Preparation Click here



1. INSPECT 2ND COAST AND OVERDRIVE BRAKE DISC


C067852
  1. Check whether the sliding surfaces of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed number is defaced, replace all the discs.
    2. Before assembling new discs, soak them in Toyota Genuine ATF WS for at least 15 minutes.



2. INSPECT 2ND BRAKE BRAKE DISC


C067852
  1. Check whether the sliding surfaces of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored or even if a part of the printed mark is defaced, replace all the discs.
    2. Before assembling new discs, soak them in Toyota Genuine ATF WS for at least 15 minutes.



3. INSPECT 1ST AND REVERSE BRAKE DISC


D025046
  1. Check to see if the sliding surface of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all the discs.
    2. Before assembling new discs, soak in Toyota Genuine ATF WS for at least 15 minutes.



4. INSPECT 1ST AND REVERSE BRAKE RETURN SPRING SUB-ASSEMBLY


C059838
  1. Using vernier calipers, measure the free length of the spring together with the spring seat.

    Standard free length:
    13.96 mm (0.5496 in.)