Home › TRANSMISSION ยท U340E AUTOMATIC TRANSAXLE › INPUT SHAFT

INPUT SHAFT > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT CLUTCH CLUTCH DISC


C067851
  1. Using a screwdriver, remove the snap ring.

  1. Remove the flange, 4 discs and 4 plates from the input shaft.



2. REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY


D008368E01
  1. Using SST on the clutch balancer, compress the return spring with a press.

    SST
    09320-89010  

    NOTICE:
    Do not compress the return spring excessively.

  1. Using a snap ring expander, remove the snap ring.



    D008369
  1. Remove the clutch balancer and piston return spring.



3. REMOVE FORWARD CLUTCH PISTON


C067856
  1. Place the input shaft onto the oil pump.

  1. Holding the forward clutch piston by hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the oil pump to remove the forward clutch piston.

    HINT:
    When the piston can not be removed due to being slanted, either blow the air again with the protruding side pushed or remove the piston using needle-nose pliers with their tips wrapped in protective tape.



4. REMOVE FORWARD CLUTCH PISTON O-RING


C067857
  1. Using a screwdriver, remove the clutch piston O-ring from the forward clutch piston.



5. REMOVE INPUT SHAFT OIL SEAL RING


C067858
  1. Using a screwdriver, remove the input shaft oil seal ring from the input shaft.