Home › TRANSMISSION ยท U340E AUTOMATIC TRANSAXLE › INPUT SHAFT

INPUT SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL INPUT SHAFT OIL SEAL RING


C067858
  1. Coat a new input shaft oil seal ring with Toyota Genuine ATF WS, and install it into the input shaft.



2. INSTALL FORWARD CLUTCH PISTON O-RING


C067857
  1. Coat a new clutch piston O-ring with Toyota Genuine ATF WS, and install it into the forward clutch piston.



3. INSTALL FORWARD CLUTCH PISTON


C068199
  1. Install the forward clutch piston into the input shaft.

    NOTICE:
    Do not damage the O-ring.



4. INSTALL FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY


C067854
  1. Install the return spring and clutch balancer into the input shaft.



    D008368E01
  1. Using SST, a press and snap ring pliers, install the snap ring onto the input shaft.

    SST
    09320-89010  



5. INSTALL FRONT CLUTCH CLUTCH DISC


D025109E02
  1. Install the 4 plates, 4 discs and flange.

  1. Using a screwdriver, install the snap ring into the input shaft.



6. INSPECT PACK CLEARANCE OF FORWARD CLUTCH


C067860
  1. Using a dial indicator, measure the pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Pack clearance:
    1.406 to 1.806 mm (0.05535 to 0.07110 in.)

    NOTICE:
    If the clearance is outside the specifications, select a new brake flange.

    HINT:
    There are 4 different flange thicknesses.

    Flange thickness:
    No.
    Thickness mm (in.)
    No.
    Thickness mm (in.)
    -
    3.00 (0.1181)
    2
    3.40 (0.1339)
    1
    3.20 (0.1260)
    3
    3.60 (0.1417)