Home › TRANSMISSION ยท U340E AUTOMATIC TRANSAXLE › INTERMEDIATE SHAFT

INTERMEDIATE SHAFT > INSPECTION

for Preparation Click here



1. INSPECT REVERSE CLUTCH DISC


C067868
  1. Check whether the sliding surfaces of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all the discs.
    2. Before assembling new discs, soak them in Toyota Genuine ATF WS for at least 15 minutes.



2. INSPECT DIRECT CLUTCH DISC


C067870
  1. Check whether the sliding surface of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all the discs.
    2. Before assembling new discs, soak them in Toyota Genuine ATF WS for at least 15 minutes.



3. INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY


C067872
  1. Using vernier calipers, measure the free length of the spring together with the spring seat.

    Standard free length:
    32.9 mm (1.2953 in.)



4. INSPECT DIRECT CLUTCH PISTON SUB-ASSEMBLY


C068212
  1. Shake the direct clutch pin and confirm that the check ball is not stuck.

  1. Apply low pressure compressed air to the check ball and check that no air leakage is identified.



5. INSPECT INTERMEDIATE SHAFT SUB-ASSEMBLY


C068213
  1. Shake the direct clutch pin and confirm that the check ball is not stuck.

  1. Apply low pressure compressed air to the check ball and check that no air leakage is identified.