INTERMEDIATE SHAFT > REASSEMBLY |
| 1. INSTALL DIRECT CLUTCH DRUM O-RING |
![]() |
Coat a new O-ring with Toyota Genuine ATF WS and install it into the direct clutch drum.
| 2. INSTALL DIRECT CLUTCH PISTON O-RING |
![]() |
Coat 2 new O-rings with Toyota Genuine ATF WS and install them into the direct clutch piston.
| 3. INSTALL DIRECT CLUTCH DRUM SUB-ASSEMBLY |
Coat the direct clutch drum with Toyota Genuine ATF WS.
![]() |
Align the cutout in the intermediate shaft assembly with the matchmark on the direct clutch drum and install the direct clutch drum onto the intermediate shaft assembly.
| 4. INSTALL DIRECT CLUTCH PISTON SUB-ASSEMBLY |
![]() |
Coat the direct clutch piston with Toyota Genuine ATF WS and install it into the intermediate shaft.
| 5. INSTALL DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Install the direct clutch return spring onto the direct clutch piston.
Place SST on the piston return spring and compress the springs with a press.
Using snap ring pliers, install the snap ring into the direct clutch drum.
| 6. INSTALL DIRECT CLUTCH DISC |
![]() |
Coat the 3 rear clutch flanges, 3 discs and direct clutch flange with Toyota Genuine ATF WS and install them onto the intermediate shaft.
Install the snap ring into the intermediate shaft.
| 7. INSTALL REVERSE CLUTCH DISC |
![]() |
Coat the 2 plates, 2 discs and flange with Toyota Genuine ATF WS, and install them onto the intermediate shaft.
Install the snap ring into the intermediate shaft.
| 8. INSPECT PACK CLEARANCE OF REVERSE CLUTCH |
![]() |
Install the intermediate shaft and thrust needle roller bearing onto the transaxle rear cover.
Using a dial indicator, measure the reverse clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| No. | Thickness mm (in.) | No. | Thickness mm (in.) |
| - | 3.0 (0.118) | 2 | 3.4 (0.134) |
| 1 | 3.2 (0.126) | 3 | 3.6 (0.142) |
| 9. INSPECT PACK CLEARANCE OF DIRECT CLUTCH |
![]() |
Install the intermediate shaft and thrust needle roller bearing onto the transaxle rear cover.
Using a dial indicator and measuring terminal (SST), measure the forward clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| No. | Thickness mm (in.) | No. | Thickness mm (in.) |
| - | 3.0 (0.118) | 2 | 3.4 (0.134) |
| 1 | 3.2 (0.126) | 3 | 3.6 (0.142) |