DIFFERENTIAL CASE > REASSEMBLY |
| 1. INSTALL FRONT DIFFERENTIAL SIDE GEAR |
![]() |
After applying Toyota Genuine ATF WS to the 2 front differential side gears, 2 side gear thrust washers No. 1, 2 front differential pinions and 2 pinion thrust washers, install them onto the front differential case.
| 2. INSTALL FRONT NO. 1 DIFFERENTIAL PINION SHAFT |
![]() |
Install the pinion shaft so as to align the lock pin holes in the pinion shaft and differential case.
| 3. INSPECT BACKLASH |
![]() |
Measure the side gear backlash while holding 1 pinion gear toward the case.
Referring to the table below, select thrust washers which will ensure that the backlash is within the specifications for both sides.
| Thickness mm (in.) | Thickness mm (in.) |
| 0.95 (0.0374) | 1.10 (0.0433) |
| 1.00 (0.0394) | 1.15 (0.0453) |
| 1.05 (0.0413) | 1.20 (0.0472) |
| 4. INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
![]() |
Using a pin punch and a hammer, install the pinion shaft straight pin.
![]() |
Using a chisel and a hammer, stake the differential case.
| 5. INSTALL FRONT DIFFERENTIAL RING GEAR |
![]() |
Using Toyota Genuine ATF WS and a heater, heat the front differential ring gear to 90 to 110°C (194 to 230°F).
Clean the contact surface of the front differential case.
![]() |
Install 4 new ring gear lock plates with the 8 bolts.
![]() |
Using SST, stake the ring gear lock plate.
| 6. INSTALL FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING |
![]() |
Using SST and a press, install the front differential case LH tapered roller bearing inner race onto the differential case.
![]() |
Using SST and a press, install the shim and bearing outer race onto the transaxle case.
| 7. INSTALL SPEEDOMETER DRIVE GEAR (w/ Speedometer Drive Gear) |
![]() |
Install the speedometer drive gear onto the differential case.
| 8. INSTALL FR DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING |
![]() |
Using SST and a press, install the bearing inner race onto the differential case.
![]() |
Using SST and a press, install the tapered roller bearing onto the transaxle housing.